PA300
http://mcsuministros.com/wp-content/uploads/2024/03/FEDERAL-PA300.pdf
SIRENA ELECTRONICA 100W 12VDC 4 SONIDOS C/MICROFONO PA300 FEDERAL SIGNAL
The Federal Signal P00 siren delivers exceptional value, time-tested durability, unmatched reliability, and is recognized worldwide as the industry standard. Electrical This totally enclosed, fully featured siren will operate from any 12-volt negative ground vehicle electrical system. The can be powered directly by the vehicle’s battery or through secondary power distribution centers. No matter how power is delivered, the siren is protected against most failure modes, including reversed polarity, by a fuse that is readily available and can be replaced without tools. The 300 series of sirens can provide either 100- or 200-watt output and will meet or exceed SAE J1849 and Class A requirements for sound when paired with a Federal Signal high-power speaker. Features A wide range of features comes standard with any 0 series siren. Included are 5 basic siren tones, TAP II (horn-ring transfer), PA, radio rebroadcast, and air horn sound with siren override. TAP II allows for effective intersection traffic clearing capability without removing your hands from the steering wheel or your eyes from the road. There is also a “Press-and-Hold” function, depressing and holding the horn ring will produce an alternate sound for as long as the operator keeps the horn ring circuit depressed. The siren’s PA volume level can be controlled with a rotary GAIN switch located on the unit’s backlit front panel, and radio rebroadcast volume is adjustable via an easily accessible rotary pot. The P siren also includes a permanent noise-canceling microphone that produces high quality voice reproduction without feedback squeal, and the microphone’s push-to-talk switch will override any siren tone for instant A use. Installation P00 siren packages are built small and compact measuring only 2.3”H x 6.1”W x 7.6”D and each unit comes supplied with its own “U” shaped mount bracket. There are no protruding components to interfere with mounting arrangements and all electrical connections are easy “plug-and-play” type which are located on the rear of the siren’s housing. An optional stainless steel bezel is available for flush mounting and a wide variety of switch controls that flush mount to the series siren are also available.